IZODEKOR // 3D Wall Panels Corner Installation Video | www.izodekor.co.uk скачать в хорошем качестве

IZODEKOR // 3D Wall Panels Corner Installation Video | www.izodekor.co.uk

Izodekor 3D Panel Corner Installation Video on the wall corners In this video we are going to show you how to use Izodekor 3D wall panels at a 45 degree angle cut and apply to the corners. 1- Clean your wall with a spatula 2- After measuring your wall, cut your panel 4 inches wider than the wall size. Note: You need to cut 4 cm extra to join both corners. If you have 1 corner join, cut just 2 cm extra. 3- Center your panel according to the wall size. There should be one on both sides difference of 2 cm exist. 4- Measure 2 cm on both sides and draw it. 5- Use the tip of your utility knife (45 degrees) to cut over the 2 cm that you want measured and drawn, and then clean them with sandpaper. Wear it through pressing silicone onto the wall. 6- After gluing the panel to the wall, measure the left side wall as in the Video shown and don't forget to take an extra 2cm measurements to make 45 degree to cut. Then squeeze the silicone and glue it to the wall. 7- Take the size of the wall on the right and don't forget to add 2 cm more take to cut again 45 degrees and press silicone on the wall too be liable. 8- As you can see the corners are combined very well. ● You can visit our site for beautiful wall panels. You can also contact us from our technical support line for all your questions. ● Website : https://izodekor.co.uk/ ● Phone: 01217948599 ● Instagram :   / ​   ● Facebook :   / izodekor.en​   ● Twitter :   / izodekor​   ● Pinterest :   / ​