Luna Bean Baby Casting Kit: Easy DIY Hand, Foot, and Bum Casting Instructions скачать в хорошем качестве

Luna Bean Baby Casting Kit: Easy DIY Hand, Foot, and Bum Casting Instructions

Thank you for choosing Luna Bean! Let’s create a beautiful keepsake together. We would love to see your creations! Share your photos on social media and tag #LunaBeanCasting for a chance to be featured. Buy on Amazon: https://www.amazon.com/dp/B08BYYXCCQ?... Instagram:   / luna_bean_casting   Facebook:   / castingkeepsakes   TikTok:   / lunabeancasting   Website: https://lunabean.com/ Ready to capture those tiny hands, feet, or even that adorable bum? Let’s get started! Decide what you want to cast: • Foot: Use the rectangular deep container included in your Standard or Deluxe kit. • Hand: Use any cup that is deep enough to cast up to the baby’s wrist (not included). • Bum: Use the square shallow container included in your Deluxe kit. Follow these step-by-step instructions based on your choice of casting. Step-by-Step Instructions Step 1: Make the Mold Important Tip: Using room temperature water allows your cast to dry in 4 to 6 minutes. Warmer, bath temperature water will set the mold quicker, in about 2 to 3 minutes. • Slowly mix the Molding Powder with water in the container until it turns bright pink. o Hand: use 1 cup of water o Foot: use 2 cups of water o Bum: use 2 cups of water • Wait until most of the pink color has faded before inserting your baby’s foot into the mold. • Insert your baby’s foot and keep it in place as best you can. It's okay if your baby wiggles a bit! • Once the mold starts to set, it will gently hold your baby’s hand or foot in place. • Touch the top of the mold to check if it’s firm. It shouldn’t leave any residue on your fingers! • Carefully wiggle your baby’s foot out of the mold once it’s set. Step 2: The Casting Stone • Mix the casting stone with room temperature water for 1 minute, or until fully mixed. o Hand & Foot: use ½ cup of water o Bum: use 1 cup of water • Pour the mixture into the mold. Tilt and tap the container to fill all areas inside the mold and avoid air bubbles. • Allow the casting to harden. Depending on your choice of casting, it will take 1 to 2 hours to harden. Step 3: Demolding Your Casting • Flip over the container to remove the mold. • Peel away the casting material. Peel in smaller pieces to avoid damaging any toes or fingers. • Set the finished casting to dry in a well-ventilated area for about 5 days! Optional Steps: Finishing Touches • Use the extra components to add your finishing touches to your casting! • Once fully dry, apply 2 to 3 coats of sealant to your casting to prevent mold over time. • Use the provided paint colors or any other acrylic paints to add your final personal touches! We hope you enjoyed creating this special keepsake! Don’t forget to share your adorable creations with us on social media and tag #LunaBeanCasting for a chance to be featured.