Nissan Altima-te AWD Concept (2019) скачать в хорошем качестве

Nissan Altima-te AWD Concept (2019)

Like the Rogue Warrior which debuted at the 2016 Montreal International Auto Show (MIAS), the Nissan Altima-te AWD was modified entirely by Quebec-based Motorsports in Action (MIA), using the DOMINATOR® track system from American Track Truck. The tracks measure 1,220 millimetres/48 inches long, 750 millimetres/30 inches tall and 380 millimetres/15 inches wide. The Nissan Altima-te AWD required more extreme body and chassis modifications compared to the changes that were made on the Rogue Warrior project vehicle. The most prominent exterior modification to Altima's exterior is seen in the front and rear fenders that were flared out by 180 millimetres/7 inches on each side, to accommodate the DOMINATOR, track system, expanding the total body width by 360 millimetres/14 inches. This results in a noticeably assertive stance, while maintaining Altima's sedan design essence and flowing lines. To modify the fenders, the MIA team applied a complex process involving the design and fabrication of a bespoke wide body kit, and building the fender part using high-density foam and epoxy resin typically used in nautical structures. This process alone amounted to over 150 hours of work. The total project took 250 hours to complete. The extreme fender flares allow a reduction in snow projections, which could impede the driver's visibility. In order to make the Nissan Altimate-AWD fully functional, the vehicle's ride height required an increase. MIA designed and built the necessary components to raise the car by 80 millimetres/3 inches. To achieve this, the front and rear load-bearing chassis were dropped by 30 millimetres/1.18 inches and the suspension components were raised by 50 millimetres/1.96 inches. The suspension geometry was corrected to offset the deviation caused by the ride height change, and restore the proper kinematics.