TV STAND - PART I скачать в хорошем качестве

TV STAND - PART I

If you’re interested in building this project, check out the links below of the items I used in the build (not all items are exactly what I used, but are similar)(As an Amazon Associate I earn from qualifying purchases): Festool Router https://amzn.to/38KGuCC 1/2 Inch Straight Router Bit https://amzn.to/3nqYMgc Irwin 6” Quick Grip Clamps https://amzn.to/3kAYW3M Combination Square https://amzn.to/3oujCwR Stacked Dado Saw Blade https://amzn.to/3e8Pcvk Japanese Pull Saw Set https://fave.co/3pDgVJA Cabinetmaker’s Chisel Set https://fave.co/35BQkVk Sjoberg Benchtop Vise https://amzn.to/2HAtS69 Kreg Router Table https://amzn.to/3mroO2o Bullnose Router Bit https://amzn.to/32Tn8HT Feather Board https://amzn.to/3jxAkYb Dewalt 20v Orbital Sander https://amzn.to/31QONIZ Acid (Glue) Brushes https://amzn.to/2HDgXzZ Titebond II Wood Glue, 16 oz https://amzn.to/31Qf1et Bessey 40” Parallel Clamps https://amzn.to/2HK7TJG Bessey 31” Bar Clamps https://amzn.to/31LWujG Irwin 24” Bar Clamps https://amzn.to/31ONkTi Dewalt 20v Cordless Drill https://amzn.to/34BrmoS Polyurethane (satin) https://amzn.to/3kAgahv Mineral Spirits https://amzn.to/34AsfxM Cotton rags https://amzn.to/35DyXCx Nitrile Disposable Gloves https://amzn.to/3jz4Xws 8 Inch Furniture Legs https://amzn.to/35CQJXD Tape Measure https://amzn.to/37RzMu6 Dust Mask https://amzn.to/2HKbass Dewalt Safety Goggles https://amzn.to/3jImhiV Ear Plugs https://amzn.to/2HKztGn Here is a list of other tools in my shop I used (I am not affiliated with these): Grizzly G0771Z Hybrid Table Saw https://www.grizzly.com This TV Stand is designed for a large TV that has about a 65” wide footprint. I special ordered some 3/4” Europly walnut plywood from The Home Depot and had them cut it to my specifications. Having it precut saved me from having to handle the large pieces on the table saw and it didn’t cost any extra money. It is a very simple design, and since there are no voids in the Europly plywood and has a very pleasant edge I decided to leave the edges bare and just round them over using a bullnose bit on the router table. I finished it off with a few coats of wipe on poly.