How to change to a MTKT Undertray on a Speedfight скачать в хорошем качестве

How to change to a MTKT Undertray on a Speedfight

MTKT - Bakre Underkåpa (Speedfight2) http://www.twostroke.se/group.asp?gro... Great for cover for your Speedfight2! Description: Really delicious in the hood that gives your Speedfight2 a unique style! The casing is made of ABS plastic. Fits backlight NOTE: The hood is attached in the same way as the original cover. Comes with a few longer screws and spacers that replace the original screws to backlight.(Abutments have a length of 30mm and an outer diameter of 10mm) -------------------------------------------------- -------------------------------------------------- ------- Here is a description on how to assemble a MTKT rear cover. 1st You start by assembling the mudguard from the moped, and unplugging flasher 2nd Since when is the so screw the cap that sits along the saddle. After the screw and disconnect the entire backlight. 3rd You got a box of accessories for the hood and in the lies screws with spacers. 4th Now that the cover is, you take the spacers and screws, and draws on backlight. with them. This allows the lamp to move any farther, so that the cap can sit on. 5th Now sit backlight. on and attaching the hood in the same place from the beginning. 6th flasher can be attached as one wants, one option is to drill a hole in the hood and disconnect the cables in the old blinker wires. There is a coil bolted to the frame, so if you turn it off and attach it with stripes in the further up you'll see that the cover fits perfectly when you attach it as it should sit. 7th Now take undertray and stuck behind the cover along with the saddle. If not positioned properly yet so pick up a flat screwdriver and remove the cover along the saddle and press down so the tape out. NOTE. PRESSURE VERY GENTLY (CAUTION). 8th Now, take the screws that will fit a flat head screwdriver and screw the cap so it sits. You saw it came with a foam with a sharp piece of tape on it, attach the upside back to the lamp. adhesive must be at upside This makes the lamp is pressed against the hood of the tracks.