RaceGOW5 Track 8 Submission / EMX FPV скачать в хорошем качестве

RaceGOW5 Track 8 Submission / EMX FPV

Tinywhoop used for this submission: BetaFPV Air65 with HappyModel 23000KV motors & WeBleed red air frame. Pushed and pushed and pushed and PUSHED and pushed some more. Extremely proud of my progress. Damn that second lap mess-up that cost me sub 50 😭. Every pack after 276 just got worse and broke more whoops. Sigh! Submission Pack: 276 Total Packs: 308 [My Gear] Goggles HDZero Goggles SpeedyBee 5.8GHz Receiver (SB-GR58-AT) Radio Radiomaster TX16S Mark II Radiomaster Ranger Micro 2.4GHz ELRS Module Check out RaceGOW5 here: https://www.racegow.com/ What is RaceGOW? RaceGOW is a series of 8 “mini UTT” tracks designed to be small enough to be built in most homes. All RaceGOW tracks will fit in a 4’ x 6’ rectangle (if you are using the minimum gate size of 24”) but you will need some additional space around the outside of that to fly the tracks optimally. You will need to build the tracks according to the video and diagram and fly them as shown in the flythrough video. Your goal is to get your fastest 3 consecutive lap time and submit clip and time via the website: RaceGOW.com If you are using PVC for gates you will need the following to build the RaceGOW tracks: 20 - sections of PVC (24” min gate size center to center, no maximum size but all your gates must be the same size. You must scale the entire track up equally based on your gate size) 4 - elbow connectors 6 - Tee connectors 6 - 4-Way Connectors 2 - 5-Way Connectors (the higher direction connectors are not required but make some connections easier) Classes & Whoop Requirements RaceGOW5 Classes: What drones are allowed? The Main Leaderboard is Open Class: Any Quad! No size limit, no battery cell limit, no ducts required. You must be able to record your DVR and/or the full flight area LOS with a timer in view. An OSD timer is strongly encouraged and recommended but not absolutely necessary** Sizing up your gates and flying with a larger drone and bigger gates outside is allowed RaceGOW is not responsible for damages if you think flying 5” 6S inside is a good idea EMAX Nanoscout Spec Class sponsored by EMAX USA: You must use an unmodified Nanoscout Frame You must use the 08015 22000kv Nanoscout Motors You must use the Nanoscout Flight Controller You are allowed to remove the plugs and direct solder the motors wires to the FC. All builds must be 1S, but any battery connector or size is acceptable You can use any props, any camera, and any type of VTX that you choose. Velocidrone Class: Any 1S whoop in available in Velocidrone (Beta 75x is NOT ALLOWED because it’s 2S) Must participate on the official track You do not need to submit a video for this class. Common Questions Can I participate in more than one class? Yes, you are allowed to participate in all the classes. If you use a Nanoscout only you will be listed on the Main Leaderboard and the EMAX Nanoscout Spec Class Leaderboard. You do NOT have to submit two different runs. You DO NOT need to include a clip of your Velocidrone run, as long as you are on the official leaderboard at the deadline of the track you will be listed on the Velocidrone Leaderboard. #RaceGOW5 #BetaFPV #Tinywhoop #FPV #Drone #Dragonball