Product No. 570 Green Slope Elevating Compound For Low Spots Application Demonstration скачать в хорошем качестве

Product No. 570 Green Slope Elevating Compound For Low Spots Application Demonstration

This video demonstrates the application of Product No. 570 Green Slope Elevating Compound For Low Spots. Product No. 570 Green Slope Elevating Compound is a premium quality lightweight self-leveling elastomeric puddle patch designed for use on flat to low sloped roofs. PRODUCT NO. 570 is 100% acrylic ensuring the highest elongation and water resistance. APPLICATION: Proper protective clothing and PPE should be worn when applying products. It is normal to see a small amount of separation when first opening a pail. PRODUCT NO. 570 is a self leveling puddle patch. Pour PRODUCT NO. 570 into low spots at a depth of up to 1/2″. If a low spot is greater than 1/2″ deep, it is recommended to address it structurally according to local codes/ordinances. If PRODUCT 570 is used in these situations, build up in separate layers no greater than 1/2″ in thickness until the desired thickness is achieved. Cure time for each layer will range from 24 hours to weeks depending on temperature, thickness, and humidity. Once cured, apply two coats of a Tucson Rubberized Coating top coating. Do not dilute product. Tucson Rubberized Coatings Products should not be applied when freezing temperatures or rain is expected within 24 hours of completed application. During application, roof surface temperatures should be between 40 and 115 degrees Fahrenheit, with no moisture present. DO NOT APPLY TO ANY SURFACES THAT CONTAIN SILICONE. STORAGE: Product should be stored in a clean and dry area, away from direct sunlight and protected from freezing. CLEAN-UP: Clean brushes, tools and other equipment with warm soapy water immediately after use. Dried film may require paint remover. COMPLIES WITH: ASBESTOS FREE HANDLING PRECAUTIONS: Product safety information required for safe use is not included. Before handling, read product safety data sheets and container labels for safe use, physical and health hazard information. Safety data sheets are available on the TRC website at www.rubberized.com. You can also obtain a copy from one of our local TRC stores. LIMITED WARRANTY AND DISCLAIMER: To the best of our knowledge, the technical data contained herein is true and accurate at the date of issuance and is subject to change without prior notice. User must contact TRC to verify correctness before specifying or ordering. No guarantee of accuracy is given or implied. Liability, if any, is limited to replacement of product unless installed by an approved contractor in accordance with TRC warranty procedures and program. For limited manufacturer’s warranty and disclaimer information, visit our website at: www.rubberized.com.