How to replace the M3i bike communication wire скачать в хорошем качестве

How to replace the M3i bike communication wire

Applies to M3 and M3i Indoor Bike and TBT models Video Contents: 00:11 Tools & Materials 00:17 Removal 03:34 Installation 06:32 Check Wire Connection 06:58 Re-connect & Route Computer Wires 07:54 Close Computer Housing 08:26 Complete the Installation Tools and materials required: • #1 Phillip Screwdriver • #2 Phillip Screwdriver • Paper Clip • Tape • Microfiber Cloth • 6 mm Hex Key (Fixed Handlebar) • Soap-Water Mix (Recommended) • Needlenose Pliers • Replacement Communication Wire • Replacement Pin Hole Covers NOTE: For M3/M3i Total Body Trainers servicing, follow the same steps with the exception of the stop pin section of the procedure. Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely service Keiser machines. This procedure should not be attempted by “do-it-yourselfers.” For further assistance, visit https://www.keiser.com/support ⚠ DISCLAIMER: While KEISER Corporation strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness, or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All service or maintenance procedures entail some risk. It is the sole responsibility of the viewer to assume this risk. KEISER Corporation is not responsible or liable for any loss, damage, (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.