Arduino Servo Motor Control with Potentiometer скачать в хорошем качестве

Arduino Servo Motor Control with Potentiometer

Control the position of the Servo motor with the Arduino and the potentiometer. Required Hardware: Arduino Board https://amzn.to/2LZr6t4 Servo Motor https://amzn.to/3avwe1N 10k ohm Potentiometer https://amzn.to/3dlgYq1 Jumper Wires https://amzn.to/3doetmT Mini Breadboard https://amzn.to/2M15Wea Recommended Items: Use Your Muscles in Project - https://amzn.to/3wdL45C 37 Sensor & Module Packages - https://amzn.to/3m66WeQ Try this Robot Arm - https://amzn.to/3fq8DCl Best Resin 3D Printer - https://amzn.to/39tY8KB Arduino Compatible Kits - http://bit.ly/2J2AFF7 Banggood Spring Sale - https://bit.ly/3slMbOn Servo motors have three wires: power, ground, and signal. The power wire is typically red, and should be connected to the 5V pin on the Arduino or Genuino board. The ground wire is typically black or brown and should be connected to a ground pin on the board. The signal pin is typically yellow or orange and should be connected to pin 9 on the board. The potentiometer should be wired so that its two outer pins are connected to power (+5V) and ground, and its middle pin is connected to analog input 0 on the board. I recommend! You not connect directly the servo motor to the Arduino. I suggest you use external power to the servo. SG90 Mini Servo motors can be used. Get Source Code: https://create.arduino.cc/editor/mert... Social Media:   / mertarduino     / mertarduino