How to Mix Mapei Grout Mixing Ultracolor Plus FA скачать в хорошем качестве

How to Mix Mapei Grout Mixing Ultracolor Plus FA

Grout can be use for both commercial and residential construction suitable for both interior and exterior installations. Mixing Procedures 1. For best results, have the same person mix all of the grout. Consistent mixing techniques will promote more uniform results. 2. Before mixing the grout with water, dry-blend the product to avoid color variations in the finished grout, which may arise from pigment settling during shipment. If two or more bags are to be used, all of the contents should be dry-blended together. 3. Mix Ultracolor Plus FA with cool, clean water only. Do not mix with grout additives. Mix by using the following water-to-grout proportions: Ultracolor Plus FA powder 10 lbs. (4.54 kg) 25 lbs. (11.3 kg) Water 1 to 1.1 U.S. qts. (0.95 to 1.04 L) 2.6 to 2.8 U.S. qts. (2.46 to 2.65 L) 4. Pour the required measured amount of water into a clean mixing container. Gradually add the proportionate amount of Ultracolor Plus FA while slowly mixing. To avoid shade variation of the finished joint, always add the powder to the water while being consistent in the mixing process and the quantity of water used from batch to batch. ® Plus FA Plus FA Note: When mixing 25-lb. (11.3-kg) bags, it might be necessary to mix partial bags. In this situation, a 3-to-1 ratio of powder to water can be mixed by volume. When using this ratio, keep in mind that it is a starting point: You might need to use slightly more or less powder or water in order to fine-tune the consistency of the mixture. 5. Mix thoroughly with a low-speed mixer (at about 350 rpm) for about 4 to 5 minutes, or until obtaining a smooth, creamy, homogenous paste consistency and a uniform shading of the colored grout. 6. Avoid prolonged mixing, which will trap air and shorten the pot life. 7. Wash tools immediately with fresh water.