Injection pump repair Part 2 Replacing the Membrane Seal Oil change Zafira B z22se Z22YH B Astra H скачать в хорошем качестве

Injection pump repair Part 2 Replacing the Membrane Seal Oil change Zafira B z22se Z22YH B Astra H

1:    • Ремонт ТНВД Часть 1 Горит ключ мясору...   2:    • Ремонт ТНВД Часть 2 Замена Сальника М...   3:    • Ремонт ТНВД Часть 3 Манжета подшипник...   4:    • Ремонт ТНВД Часть 4 Замена масла Дора...   0:00 Drill a hole in the injection pump housing under the retaining ring 01:01 Other options for modifying the injection pump for ease of maintenance 02:05 The easiest way to improve 03:16 How to fill and change the oil in the injection pump? 04:03 Check after modification and oil change Healthy everyone! I finally climbed here myself))) In general, I figured it out! I’m ready to share information on the repair and maintenance of the high-pressure fuel injection pump on Opel cars. In this case, the fuel injection pump for Opel Zafira B, engine z22yh 2.2 Direct, was being repaired. Let's go!!! https://prom.ua/p1482725959-salnik-ma... From personal experience - fuel injection pump repair. Symptoms: When starting, the engine stalls, misfires, the “machine with key” error appears on the dashboard, sometimes the “meat grinder” check engine just lights up, when reading errors, an error code appears on the dashboard - 11915a. Also, these errors may not occur immediately, but with an increase in engine speed to about 3000 rpm. After these errors appear, the ECU automatically switches the engine operation to emergency mode and the engine does not accelerate above 2000 rpm, the vehicle speed drops to about 10-30 km/h no higher. At the same time, the car does not stall, but simply works as if it is missing something. One of the reasons most likely may be a malfunction of the injection pump (high pressure fuel pump). How to correctly diagnose the problem and repair the injection pump? computer diagnostics of the ECU is needed, since you need to find out what fuel pressure in the engine goes after the injection pump into the engine. You can decipher errors yourself by reading the error code from the dashboard, but only a computer connected to the computer will show you a more accurate fault. So don't waste your time. Comp. Diagnostics can be done at any service station, some can do it for free. In my case, the pressure in the pump was 0.4-0.5 atmospheres, but it should be 50 atmospheres!!! And yet the car still somehow worked!!!))) and so, if you make sure that the pressure is below normal, you need to visually check the injection pump assembly itself, check the reliability of the fasteners, tubes, bolts, clamps, and also check the mesh for contamination. if everything is normal with the fastenings and the mesh, we move on to the injection pump itself, carefully unscrew the pump and disassemble it. next we check all the rubber parts, gaskets and seals, pay attention to how all these parts are located, whether there are any breaks, bubbles and other damage or deformations of the rubber gaskets, seals and membranes. It is very common for the membranes to break or the oil seal to come out of the grooves; all this leads to a loss of pressure in the fuel system, which leads to engine malfunction. In my case, the pressure in the injection pump is normal at 50 atmospheres (Opel Zafira B 2.2 Direct z22hy) Support the channel with any amount. Financial support for our efforts will make our product better. Therefore, we will be grateful for financial support for the project. https://donatepay.ru/don/630700 Link to repair kit without membranes - https://repairkit.com.ua/p1482725959-... Link to repair kit with membranes - https://repairkit.com.ua/p1689086870-... If it's not difficult, share a link to the channel with your friends. https://www.youtube.com/c/SalDivitta?... Thanks to!) 🌟SUBSCRIBE FOR MORE GAMPEPLAYS: https://www.youtube.com/c/SalDivitta?... Injection pump repair Part 2 Replacing the Membrane Seal Oil change Zafira B z22se Z22YH Opel Zafira B Astra H #zafira #fuel pump #opel