AMT Galileo II Model build with LED lighting by TrekWorks скачать в хорошем качестве

AMT Galileo II Model build with LED lighting by TrekWorks

From Trek Works A build up of the AMT/Ertl Galileo II model kit. Check out this video to see how to build your Galileo with lighting. For the build, the model was assembled as per the instructions. A small hole was drilled in the interior control panel at the center. This was done to mount a single 5MM white LED in place for the interior lighting. The wire for the LED is then run to the rear of the model and a small notch was cut at the bottom of the rear interior wall. This was to allow the wire to pass through to the rear compartment. There a connector jack was installed . It was then wired to the forward LED with a 150 ohm resistor in between. A fabbed cover of sheet styrene was placed over the wiring at the floor and the model was assembled and painted. A 4.5 volt DC power supply was added and we have a nice looking although not totally accurate model of the Galileo Shuttle Craft with some cool interior lighting. Total cost less than $40 bucks for everything including the power supply. This is a great kit for beginners to start with. There are not too many parts and the painting needed is minimal. The decals are fairly large and not too difficult to work with. A great little kit that looks really good built up. Hope you'll pick one up and give it a go. For more kit reviews, builds related to star trek, check out our new channel TrekWorks for all this and much more. See you there.