У нас вы можете посмотреть бесплатно Servo Test - 7 popular micro (9g) servos compared или скачать в максимальном доступном качестве, видео которое было загружено на ютуб. Для загрузки выберите вариант из формы ниже:
Если кнопки скачивания не
загрузились
НАЖМИТЕ ЗДЕСЬ или обновите страницу
Если возникают проблемы со скачиванием видео, пожалуйста напишите в поддержку по адресу внизу
страницы.
Спасибо за использование сервиса ClipSaver.ru
About 5 months ago, I can't believe it was that long ago, I made a video comparing some popular micro servos. It was a pretty basic video, with one of the criticisms being that it wasn't overly scientific. You can check out that original video here • Servo Comparison . So, this video properly tests the servo's strength and current draw at stall. Each servo is tested for all voltage levels that it is rated for, as well as a general base amp reading. The test rig consists of: A 4S graphine LiPo, to supply more than enough power A UBEC with 5, 6, and 7.4 volt output levels, with a maximum current rating of 6A An L9R receiver, to command the servos A voltage and amp display, to show what the servo is drawing An electronic 10Kg travel scale, to measure the torque Contents 00:00 Introduction 01:01 The test rig 04:19 MG90S 15:30 ES08A II 14:47 ES08MA II 23:51 ES08MD II 29:11 MG90D 32:53 ES3352 37:11 DS939HV 45:09 Results table I tested the following servos: Banggood "TowerPro" MG90S (4.8v & 6v) EMAX ES08A II (4.8v & 6v) EMAX ES08MA II (4.8v & 6v) EMAX ES08MD II (4.8v & 6v) Banggood "TowerPro" MG90D (4.8v & 6v) EMAX ES3352 (4.8v & 6v) Corona DS939HV (4.8v, 6v, & 7.4v) If you found this video useful, please give it a thumbs up. For more content, please subscribe and click the bell icon. Please feel free to join in the fun at / fixedwingrcrebels too. Also, if you found my videos useful, and would like to leave me a little tip, you could always buy me a Coffee at https://www.mrd-rc.com/go/ko-fi/