RapidChange ATC Video #2 Mini SD, G-M Code Commands and Macros скачать в хорошем качестве

RapidChange ATC Video #2 Mini SD, G-M Code Commands and Macros

RapidChange ATC Video #2 Mini SD, G-M Code Commands and Macros M-code Commands: M0 (M (Zero)) Used alone M0 will pause the program M99 Ends all current running codes M3 (S1500) Spindle on CW at 1500 RPM Example M3S1500 turns spindle on clockwise at 1500 RPM M4 (S1800) Spindle on CCW at 1800 RPM Example M4S1800 turns spindle on counter-clockwise at 1800 RPM M5 Used alone M5 will turn “spindle” off M6 Tool Change Example M6T1 is changing to tool 1. program will unload current tool and load tool #1 M8 Used alone M8 will turn “coolant flood” on This is where the ATC dust cover is connected to for opening the dust cover. Coolant on = open dust cover M9 Used alone M9 will turn “coolant flood” off This is where the ATC dust cover is connected to for closing the dust cover. Coolant off = close dust cover M61 (Q4) Assign tool to spindle Example M61Q4 will assign tool 4 to spindle Reference G-Code G65P203 G-Code Commands: G65 (M-command on SD card) enables calling an M-command sub-program Example G65P203 will call the P203 macro created from the RapidChange website that you copied to your SD card. Reference M-Code M61 Reference Macros G4 Dwell/Pause spindle XYZ movement (P for seconds) Example G4P5 will allow the spindle to wait 5 seconds to ramp up before other commands will be used. G53 predetermined set location This predetermined location is set in the RapidChange website WEBUI for the tool setter during setup. G90 Absolute Coordinates This command tells the program to use “absolute” coordinates and not “relative” coordinates In gsender, the coordinates in Blue are relative to where you set your 0 (Zero) location. The coordinates in Gray are absolute machine coordinates no matter where you set your 0 (zero). G0(Zero) This code tells your machine to move using “Rapid” moves G43.1 Use tool length offset This is used in the code when you go from one tool to the next to adjust the height of the bit to reference the Z0 location. G20 use inches as unit of measurement G21 use millimeters as unit of measure The unit of measure for these programs are in MM **IMPORTANT** THIS IS ONE OF MANY REASONS WHY THE FIRMWARE IN GSENDER MUST BE SET TO MM AND NOT INCHES BY DEFAULT. G38 (.1, .2, .3, .4, .5) probing used for tool setter G38.5 is used along with other commands to send the tool Z to touch off on the tool setter at a specific speed. This is set in the RapidChange WEBUI MACROS on SD card from RapidChange WEBUI (G-Code G65 with these Macros can be used manually in the command prompt in gsender to activate these Macro subprograms) TC = Tool Change P208 = Open Cover P209 = Close Cover P231 = Measure current tool P200 = Find Z Position (used in setting up the tool changer sensors) P201 = Before tool change P202 = After tool change P203 = Show current tool