How to replace the diesel fuel filter- Mitsubishi triton MN/L200 [ DIY ] скачать в хорошем качестве

How to replace the diesel fuel filter- Mitsubishi triton MN/L200 [ DIY ]

This time on the channel, I show you how easy it is to change you're fuel filter in a MN & ML triton. ML - 3.2L (4M41 engine) 2006 - 2009 MN - 2.5L (4D56 engine) 2009 - 2015 ▪ ▪ 0:00 - Step 1. Removing the fuel filter & hoses/wires 0:46 - Step 2. Removing the Water sensor from the fuel filter 1:46 - Step 3. Removing the fuel filter from the housing bracket 2:45 - Step 4. Where & how to dispose of the old fuel filter 3:05 - Step 5. Installing the new fuel filter onto the housing 3:53 - Step 6. Installing the water sensor 4:30 - Step 7. Putting the filter back into the engine bay 5:28 - Step 8. How to bleed the fuel system Please note, Step 8 is how you do it but in my triton, it takes me longer to bleed due to the Ryco pre diesel filter that is run before the factory filter which needs to fill before it will reach the factory filter. For every other MN triton, all you do is pump the valve on top as shown till it gets hard to push. Now try & start the vehicle. it may run for a few seconds then stall which is normal. Go back to the engine bay and pump it again till it goes hard again then try starting it once again. it should stay running now. Tools required? Flat head screw driver Filter removal tool Bench mounted vice Soft jaw pliers Ryco fuel filter used: https://www.supercheapauto.com.au/p/r... This is a demonstration on how I did this to my vehicle. I will NOT be held accountable for any damages you may/can cause following these steps. if you DO NOT know what you are doing, Take it to a qualified auto mechanic and have them change it for you Video was shot with a Gopro hero 8 Be sure to like & subscribe to our YouTube channel for all upcoming videos👍 📷 Instagram: gettin_dirty_4x4_adventure 🎥 YouTube: Gettin Dirty 4x4 Adventure