ESP32 #2: Soldering the ESP-WROOM-32 to a breakout board (Part 1) скачать в хорошем качестве

ESP32 #2: Soldering the ESP-WROOM-32 to a breakout board (Part 1)

Disclaimer: The particular module I was soldering had issues with programming, so it's possible that it was damaged during the soldering shown in this video. Exercise caution when soldering the ESP32 with a soldering iron... This is first of a two part video where I solder the ESP32 module (ESP-WROOM-32) to a breakout board. In this video, we'll take a closer look at the ESP32 module's package, and after that I prepare the breakout board for soldering of the ESP32 module by applying flux, and then use regular solder and soldering iron to solder the ESP32 to the board. Along the way, I don't do a good job soldering, so I need to use some wick to correct the solder joints and such. In Part 2 (   • ESP32 #3: Soldering the ESP-WROOM-32 to a ...  ), I will be soldering the ground pad of the breakout board to the ESP32 module's ground pad, and use the continuity mode of the multimeter to check that the connections are being made properly.