Triminator Dry Marijuana Trimming Machine Assembly Guide - Assembling Triminator Dry Bud Trimmer скачать в хорошем качестве

Triminator Dry Marijuana Trimming Machine Assembly Guide - Assembling Triminator Dry Bud Trimmer

The Triminator Dry is a bud trimmer that is gentle and fast. Designed around the needs of the grower, it sets a new standard by producing beautifully trim buds, and clean, pure trim for extraction. https://www.thetriminator.com/ We drew on over 30 years of equipment manufacturing experience and expertise in cannabis harvesting, and focused on delivering the tightest trim with minimal impact to the flowers and trichomes. To do this, we reimagined the form factor, narrowing and lengthening the drum to reduce impact on the flowers and to maximize the cutting surface. What we created is a machine that is fast, efficient, cost effective, and easy to assemble. Here is Dana, from The Triminator, to show you just how easy it is to assemble your Triminator Dry Marijuana Trimming Machine. Hi, I'm Dana with The Triminator and I'm here to show how to assemble the Triminator Dry. When the machine arrives, it's going to arrive in two non-descript cardboard boxes. The first will have the machine body, and the second will have the floor stand. You're also going to receive the trim bin, and a pull pin. To perform this task you will need three basic tools: a 7/8 inch wrench, a 3/4 inch wrench, and a 5/16 allen key. First thing you'll want to do when you get the floor stand is move the wheel from the inside. Simply unscrew it and place it on the outside. To tighten it, use your three quarter inch wrench. The next step is to attach the stand to the body. To do this, you want to make sure that things are oriented correctly. You want the body so that it's vertical and it's sitting on its nose, and you'll want the stand so that the pull pin hole aligns with the pull pin holes on the body. Next, you'll want to move the bolts to the outside of the stand and rotate it into position. Use your allen key to tighten the bolt and repeat it on both sides. The next step is to install the pull pin into the pull pin hole. Ultimately, you'll want the pull pin to align with the indexing hole. To do this, lift the stand body slightly so that it aligns with the hole. Tighten by hand, and then with your seven eighths wrench. To get the machine into position, you want to make sure that the pull pin is engaged in a hole. This is very important because you don't want the machine body to swing as you elevate it into position. Once you know that the pull pin's engaged, lift up and rock it into position. Complete your assembly by inserting the trim bin. The Triminator Dry should be ready to go. Contact us - https://www.thetriminator.com/schedul... - 530-265-4277 Get a demo - https://www.thetriminator.com/contact/