Скачать с ютуб DIY charger for small Li-Ion Batteries: 3D printed and TP4056 powered в хорошем качестве

DIY charger for small Li-Ion Batteries: 3D printed and TP4056 powered

If you have 10440 batteries to charge and are considering using the popular TP4056 module, this video is for you! I’ll walk you through how I swapped the 1.2k Ohm resistor on the TP4056 module for a 4.3k Ohm resistor to lower the charging current, helping your 10440 batteries last longer. Taking a step further, I've also designed and 3D-printed a custom enclosure to hold two chargers, allowing for parallel charging of two batteries. The enclosure features snap-fit joints, so no additional fasteners are needed. For cheaper prices, check AliExpress Choice or Shopee for TP4056 modules and battery holders. I got both for around RM1 each, plus resistors for RM0.10 each. The total cost of components, excluding the 3D print, is RM4.20 which converts to about 1 USD Anyway, I'd love to hear your thoughts if you do try this out! STL link: https://www.printables.com/model/1145...