Drilling procedure for XGate Dental X11 and X3 Pure&Porous Implant 4.2 mm diameter bone type D1 скачать в хорошем качестве

Drilling procedure for XGate Dental X11 and X3 Pure&Porous Implant 4.2 mm diameter bone type D1

🦷 XGate Dental Drilling Protocol https://xgate.dental/wp-content/uploa... 🦷 IMPORTANT! Before installing X-Gate Dental implants, familiarize yourself with the protocol for preparing the implant site. This video demonstrates the necessary steps for placing a 4.2 mm diameter implant in dense bone with a D1 density. 00:00 First, the site should be drilled in the hardest cortical layer of a D1 bone using a special cortical bone drill bit. 00:30 Then, a 2mm pilot drill bit should be used to reach the full depth of the site, which typically ranges up to 10mm in depth, but can reach up to 16mm depending on the length of the implant. The recommended speed is 1000-1200 rotations per minute, and moderate force should be applied during drilling with intense irrigation to cool the drill bit and bone. 00:34 Next, drill bits of increasing diameter should be used to widen the site to the appropriate depth. First, a 2.5mm drill bit should be used to reach the full depth. 00:40 Then, a 2.8mm drill bit should be used to reach two-thirds of the depth. 00:46 Next, a 3.2mm drill bit should be used to reach half of the full depth, followed by a 3.65mm drill bit to reach the other half. Finally, a 3.8mm drill bit should be used to widen the site to the depth of the cortical layer, which can be 3mm or slightly more. 00:50 If resistance is encountered during drilling, the drill bit should be replaced as it may have become dull. It is important to use water during drilling to prevent overheating of the bone and thermal necrosis of the bone tissue after implant placement. Once the site is prepared, the implant can be placed into the site. 01:10 The aggressive thread profile of X-Gate Dental implants allows for good primary stability by screwing it directly into the bone tissue. The maximum torque value for implant placement is 50 N*cm. It is important to carefully follow these recommendations. Visit the company website: https://bit.ly/40A2k3L. #implantdrillingprocedure #dentalimplants #dentalimplantsurgery #dentalprotocol . ‼️ Disclaimer: Any medical or scientific information provided in connection with the content presented here makes no claim to completeness and the topicality, accuracy and balance of such information provided is not guaranteed. The information provided by XGate Dental Ltd. does not constitute medical advice or recommendation and is in no way a substitute for professional advice from a physician, dentist or other healthcare professional and must not be used as a basis for diagnosis or for selecting, starting, changing or stopping medical treatment. Physicians, dentists and other healthcare professionals are solely responsible for the individual medical assessment of each case and for their medical decisions, selection and application of diagnostic methods, medical protocols, treatments and products. XGate Dental Ltd. does not accept any liability for any inconvenience or damage resulting from the use of the content and information presented here. Products or treatments shown may not be available in all countries and different information may apply in different countries. For country-specific information please refer to our customer service or a distributor or partner of XGate Dental Ltd. in your region.