Byrna Red Dot Installation скачать в хорошем качестве

Byrna Red Dot Installation

What’s in the Box: -User manual + safety card -Byrna Red dot sight -Two Allen wrenches: -0.5 mm for windage/elevation adjustments -Torx T10 for mounting -Extra screws (not required unless replacements are needed) -Lens cleaning cloth -Elevation shim -Insulation sheet (important!) Step-by-Step Installation: 1. Prep the Red Dot Remove the protective cover on the red dot sight. Pull the battery tab to activate the unit. 2. Remove Battery Plate Use the T10 Torx wrench to unscrew and remove the bottom plate (where the battery sits). Locate the thin insulation sheet—do not discard this. It prevents electrical contact between the sight and launcher. 3. Remove Rear Optic Plate (from launcher) Use a 5/64" Allen wrench or a 3 mm Allen key to remove the optic plate. Set the plate aside. 4. Install the Red Dot Place the insulation shim on the launcher, aligning it with the two mounting holes. Position the red dot sight over the shim. Use the T10 Torx wrench to secure the red dot with the provided screws. Tighten firmly but avoid over-torquing. A quarter turn after resistance is enough. Check the red dot for proper alignment before final tightening. Zeroing & Adjustment Elevation Shim: Use only if needed. If the dot cannot be zeroed (too high/low), the shim helps tilt the red dot for better alignment. Adjusting the Dot: Use the 0.5 mm Allen key Windage (side screw) Clockwise = Moves dot right Counterclockwise = Moves dot left Elevation (top screw) Clockwise = Moves dot up Counterclockwise = Moves dot down Final Check: Once mounted and adjusted, your Byrna Pro Site is ready for use. Happy training and stay safe!