How to use the Embellish Knit Automatic Spool Loom скачать в хорошем качестве

How to use the Embellish Knit Automatic Spool Loom

Get the Embellish Spool Loom here → http://amzn.to/2Cn55LF I'm going to show you how to use the embellish knit automatic spool loom, and if you want to buy one I'll put a link in the description below. The automatic spool loom allows you to create cords for projects. It does a pretty good job and it's very fast in comparison to a spool loom. To use the embellish knit you feed the yarn through the guide and down the center hole, on the other side you'll clip the weight, this part is necessary for the yarn to feed properly through. Then you turn the handle allowing the first hook to grab the yarn, then you lift the yarn behind the second needle and allow it to be hooked onto the 3rd hook. The latch on each hook always needs to be in the open or down position at this point, so if it's not, you'll have to open it, but once you get it going it should be automatic. Then skip the fourth hook and allow the first hook to catch the loop again. From this point continue turning the handle allowing the yarn to catch on every hook. Getting this going is a little tricky, not difficult, it just takes some patience. You may need to tug slightly on the yarn that is coming out from underneath just slightly as you turn the handle, you want to make sure that as the hook raises to grab another loop of yarn that the previous loop slides off the peg. If you have a heavy weight yarn this won't work very well or at all. But with lighter weight yarns you can really get this thing going pretty fast, you just have to make sure the hook lets go of the loop before it grabs another one. You may have to give it a tug once in a while so it doesn't bunch up at the top of the tube. The only other thing you want to make sure is that there is no tension on the yarn that is being fed into the loom and that the weight is hanging freely so it can feed the yarn down the tube. Once you're done you just cut the yarn and let it finish weaving the handle. Then take a yarn needle and secure each loop so it doesn't come untangled just like you would on the normal spool loom.