Replacing a Range Radiant Surface Element скачать в хорошем качестве

Replacing a Range Radiant Surface Element

This video from Sears PartsDirect shows how to replace a radiant surface element in a range. A radiant surface element heats the surface of the ceramic glass cooktop on a range. Replace the radiant surface element with a manufacturer-approved part if it's damaged or it doesn't heat even though it's getting enough power.. Visit us at: https://www.searspartsdirect.com?sid=... Or call 1-800-437-1673 to speak with a parts specialist. The video includes these parts and tools. Look up your model to make sure you get the right parts for your range. Radiant surface element https://www.searspartsdirect.com/part... Find parts for your Range at: https://www.searspartsdirect.com/part... Or, click here to schedule an appointment with a repair technician. https://www.searshomeservices.com/rep... Transcript: The first step to replacing the radiant surface element is to unplug the range or shut off the circuit breakers for the range. Electric ranges have two breakers that are often but not always connected, shut off both breakers. Open the oven door completely and remove the screws from the bottom front lip of the glass cooktop frame. Carefully pull the cooktop assembly slightly forward to release the front lip from the front support bracket. Lift the front of the cooktop to release the frame sides from the support bracket and then pull it forward to release the hinge tabs from the slots in the backguard. Lift the front edge of the glass cooktop and prop it open, placing the prop at the center of the cooktop’s front lip where it’s most stable. Be careful not to damage the oven insulation when propping open the cooktop. If you’re replacing a front element, you can leave the rear support bracket attached. If you’re replacing a rear element, carefully remove the screws from the front surface elements’ support bracket. Hold the bracket so it doesn’t fall when you remove the second screw. Carefully lower the front elements and bracket onto the oven insulation. Remove the screws from the rear elements’ support bracket (supporting the elements and bracket as you remove the second bracket screw). Lower the elements and bracket onto the oven insulation. Mark the mounting holes on the support bracket so you can reinstall the clips in the same holes when you install the new element. Using pliers, release the element’s mounting clips from the support bracket. Transfer the wires one at a time from the existing surface element to the new surface element. Transfer the mounting clips from the existing surface element to the new surface element. Attach the rear surface elements’ support bracket and elements to the cooktop. Reinstall the screws. Attach the front support bracket and elements to the cooktop and reinstall the screws. Carefully remove the prop and lower the cooktop. Tuck the front lip of the cooktop frame under the front support bracket and lower the sides over the ends. Push the cooktop back, inserting the hinge tabs into the backguard slots. Reinstall the mounting screws in the front lip of the cooktop frame. Close the oven door. Plug the power cord into the outlet or turn on the house circuit breakers for the range. If you pulled out the range to unplug it, slide the range into position, ensuring that the rear leveling foot fully connects with the anti-tip bracket.