etrailer | In-Depth Review of the Quick Fist Original Clamps for Roll Bars скачать в хорошем качестве

etrailer | In-Depth Review of the Quick Fist Original Clamps for Roll Bars

Click for more info and reviews of this Quick Fist Tie Down Straps: https://www.etrailer.com/Tie-Down-Str... Check out some similar Tie Down Straps options: https://www.etrailer.com/dept-pg-Tie_... https://www.etrailer.com Don’t forget to subscribe!    / etrailertv   Full transcript: https://www.etrailer.com/tv-Demo-Quic... Hi there. I'm Michael with etrailer.com. Today, we're gonna take a quick look at these quick fist original clamps for your rollbars. This kit is going to include these two durable rubber jaw style quick fist clamps that will allow you to store and transport equipment on your vehicle's rollbar. So this is gonna work great for your emergency vehicles, your work trucks, off road vehicles, military vehicles, ATVs, boats, and other applications. This is going to prevent you from having to waste time reinstalling temporary holding devices like bungee cords, or straps each time you want to transport or organize your gear. Having these mounted onto your rollbars is gonna provide a nice stable point for you to connect all your work gear. This will give us the ability to tighten down our straps to provide a nice tight grip on our gear, like our shovels, axes, high lift jacks and other gear with a one inch diameter up to two and a half inch diameter and weighing up to 50 pounds if you're using both clamps together to hold it in place. These clamps can be mounted in a horizontal or vertical position. So depending on the orientation you need for whatever gear you're wanting to put in place, you can achieve that. And these clamps themselves are going to have these interchangeable snap-in inserts that will allow the system to fit your rollbars that are one inch in diameter like we have here with this smallest opening one and a half inches, one in three quarters of an inch or you can keep those inserts out and have a two inch diameter opening here. Very simple to get these installed. You'll just take one of the rubber pieces, put it on the bottom of the clamp and then surround your rollbar with the system here. Then you can use the stainless steel hardware to get those two pieces clamped onto your rollbar and then you're set to go. So you do wanna make sure that you're not mounting this above or on the rollbar any higher than the front seat or the back of the front seat to minimize the risk of a mounted object hitting someone if you we're to roll over. So just be mindful of where you're mounting these to keep everybody safe. This is constructed of a molded rubber, so it is going to withstand heat, cold, road salt and UV rays. So it's gonna hold up really well for you and it is gonna be ideal for your outdoor use. And it is rubber construction so it will provide a little bit of a shock absorbing capacity there for your equipment that you have mounted. As far as our dimensions go, I'll show you on this one. We're looking about one and a half inches in width there, looking at just this base portion. If you add in those snap-in inserts, take you up to about two inches in width. Our length is just under six inches. I'm gonna call it five and three quarters of an inch. And then our height, we're looking at right about six inches there. These are made here in the USA so you can trust they are gonna be a good quality for you. So if you are looking to get some of your gear mounted on your rollbars, these are gonna do a great job for you. That completes our look for today. Again, I'm Michael with etrailer.com. Thanks for watching..