How to Install GOtv Decoder and Antenna || installation guide 2021 скачать в хорошем качестве

How to Install GOtv Decoder and Antenna || installation guide 2021

How to Install the GOtv Antenna (Step by Step guide) Requirement 1. Pole bracket for clipping the Gotenna on a pole 2. Go Antenna 3. 2mm cable wire – about 30 meters long (Usually white) 4. Brackets and clips 5. One GoTV decoder 6. AV wire 7. Wingnuts 8. A remote controller 9. A detailed user manual Get the Gotenna and 30 meter long cable out of the box (handle with care). Pass the white or black cord wire through the Gotenna grid and screw it into the hole provided at the back of a yellow plastic box on the Gotenna. (This plastic is very visible on the Antenna). Once the cord is well secured into the plastic box, gently slid it (the yellow plastic box) through the water proofed sleeve to ensure everything is okay and well guided. Now, clip the red and green plastics on the Gotenna to the ones on the Antenna grid respectively. Ensure they are well clipped to each other before proceeding further. Search your GoTV kit or pack and look for a U-shaped bracket, take it and pass it through the middle of the of the Gotenna. (This U bracket will help the pole bracket to hold your Gotenna to the pole firmly). Now bring out the pole bracket which is included in the GoTV pack/kit. pass it through the outskirts of the U bracket with the flat side facing the antenna grid At this moment, get your pole and place it in between the outward facing Pole Bracket and then use the wingnuts from the kit and fasten up the pole to the pole bracket. You have just succeeded in setting up your Gotenna. This is all you'd need to know about how to install GOtv antenna by yourself. You can now safely proceed to how to install the decoder and start exploring the channels on your default subscription pack. How to Install GOtv Decoder (for first use) Bring out the decoder from the kit and connect it to your Television using the provided AV (Audio and Video) cables. Connect the cable (the white/black cord wire) from the yellow plastic on the antenna to the RF In plug at the back of the decoder. Connect the power cable and plug the end into a wall socket. It is recommended you use a power surge protector. Switch on the socket and power up your TV and GoTV decoder. Using your TV remote control, switch to the right AV channel where GoTV will be showing (Usually AV channel). GoTV will boot for a few seconds and prompt you to select your language option and country. After this, GoTV will launch an automatic channels scan and this might run for some minutes (About 3-8 mins). All the TV channels and stations included in your current subscription pack will appear after the scan. It should be about 100 TV channels and 4 radio stations. #gotvafrica #gotvnigeria #gotenna #installationguide #gocoder