Full-Wave Regulator Rectifier || DIY || At Home скачать в хорошем качестве

Full-Wave Regulator Rectifier || DIY || At Home

🔥Hello everyone🔥In this video, I’ll show you how to build a full-wave voltage regulator for motorcycles from scratch. If you're facing battery charging issues or weak charging, this project is an affordable and effective solution. This circuit is designed for single-phase full-wave stators and helps improve the electrical system and extend battery life. 00:00 Intro 01:16 Component list 02:21 Circuit Diagram 11:25 Zener Diod Selection 12:22 Capacitor Connection 13:05 Voltage testing with multimeter 13:23 testing with led light 14:48 Modification for this Regulator 🔧 What You’ll Learn in This Video: ✅ Step-by-step guide to building a Full Wave voltage regulator for motorcycles ✅ Circuit diagram and required components ✅ How to boost the output to 15V for faster battery charging (description read) ✅ Fixing common motorcycle charging problems 👇👇👇 ⚡ If you're interested in electronics, tech projects, and motorcycle electrical systems, don’t miss this video! Like, comment, and subscribe for more tutorials! 🔔🔥🙏 #automobile #diyprojects #motorcycle #business#makemoneyonline #makemoney #earning #technologhy #Arduino #DIY #experiment #HowTo #MotorcycleRegulator #DIYMotorcycle #MotorcycleElectrical #lifehacks #tech #smartphone #diy #usa #uk #canada #california #washington #newyork Full description of this regulator :😀 Single-Phase Voltage Regulator (Full-Wave) Here is another voltage regulator designed for motorcycles, specifically for use with a single-phase stator. This is the simplest full-wave design, commonly found in most commuter bikes with a 4-pin connector. ❗This regulator is different from half-wave versions and cannot be used with half-wave stators, where one end of the windings is directly connected to the ground. This design is only for full-wave stators that have been modified accordingly. ⚙️Features and Adjustments With the given component values, this regulator outputs 14.4V at 5000 RPM. If you need faster battery charging (especially under high load conditions), you can adjust zener diod from 12V to 13V, increasing the output to 15V. ❗Limitations This system is stator-dependent, meaning it cannot generate more power than what the stator provides. The entire charging system relies on the maximum output of the stator. LED: You can add an LED to the circuit for aesthetic purposes. To do this, simply connect the positive pin of the LED, 5 mm, to a 1 kiloohm resistor and connect it to the positive pole of the circuit. The negative pin of the LED is also connected to ground. How to rewind Magnet coil kara :    • How to Rewind CD 70 Magnet coil and increa...