COULDN'T RESIST! - Wiring GEN 4 CRUISE CONTROL For LS Swap - UTX скачать в хорошем качестве

COULDN'T RESIST! - Wiring GEN 4 CRUISE CONTROL For LS Swap - UTX

Today at Ugly Truck, we're doing the IMPOSSIBLE! We're wiring up cruise control on this Gen IV swapped C10 using the original factory column switch. The issue is that the LS donor switch uses resistors in parallel to send a signal to the BCM for the on/off, resume, set, and cancel buttons. So after some serious math and some R&D, we're giving you the Gen IV cruise control "cheat sheet"! PARTS LIST: Here's a link to the resistors we used. We had to solder some in series to get the right values, but you can also just order a single resistor for each wire with the correct value. https://amzn.to/3X1p7pN 1984 Cruise Control Switch: https://amzn.to/4dGa36z Work Cart: https://amzn.to/47rFqSr Solder BUTT Connectors: https://amzn.to/4n2lM3Y Heat Shrink: https://amzn.to/4mF30jw Non-insulated BUTT Connectors: https://amzn.to/4n7H9kI Ratcheting Wire Crimper: https://amzn.to/3UOTcao NOTE - The links above are affiliate links. As an Amazon Associate, we earn from qualifying purchases. We receive a commission from ANY purchase made through these links, at no cost to you. This helps support the channel to bring you more Ugly Truck, more often! Thank you for your support! Cruisin' The Coast - Mississippi Gulf Coast 10/6-13/2024 - cruisinthecoast.com/event-info/ Join our Facebook group, UTX: Swap Talk!   / 1199009607727297   For more helpful LS Swap videos, click here!    • LS SWAPS - Tips & Tricks - UGLY TRUCK EXPE...   Follow us on Facebook! fb.com/uglytruck Check us out on Instagram! @uglytruckexperience Want to send us something? (NEW address!) 7915 E. Division St. Strafford, MO 65757 IBLPLYGI9TDXTPTR #squarebody #lsswap #c10 #lsc10