digiDL-H Installation скачать в хорошем качестве

digiDL-H Installation

The digiDL-H is our tachograph remote download product that provides driver card and vehicle unit download as well as real-time data. It also generates its own secure local network to collect data from additional modules. Here's how to install it: Step 01: Remove the tachograph using the extraction tools. Step 02: Remove the white 'A' plug and (if present) the red 'C' plug from the back of the tachograph. Step 03: Insert the white and red plugs from the ETC (Enhanced Tacho Cable) into the back of the tachograph. Leave the yellow plug connected to itself unless required for double-plug* installation. Step 04: If there is an existing red plug, insert this into the ETC's connector block in place of the red termination plug. Step 05: Ensure that the existing white plug is the last to be connected and plug it into the ETC's connector block. Step 06: Pass the ignition and 4-pin cable through the back and out of an empty slot to be used for the digiDL-H. Step 07: Install both antennas to the corresponding sockets on the DL-H, so that the antenna colour matches the washer colour. Step 08: Tidy the cables and rest the tachograph in it's slot. Step 09: Turn on the ignition as this allows you to fully test the digiDL-H. Step 10: Connect the 2-pin Ignition cable into the IGN socket. Step 11: Connect the 4-pin CAN & Power cable into the 'C+P In' socket. Step 12: Check the lights. Red = Power Green = CAN connection to tachograph Blue = Communications - may take a few moments to check SIM and network settings and digicentral connection. White = Hub - internal WiFi network for connecting to add-on modules. Step 13: Once all the lights are on, you can tidy the DL-H away, replace any slot covers and secure the tachograph back into position. *Double-plug installation: For the Yellow (B) plug, if the vehicle has a conjoined A and B plug, remove the conjoined plug and insert into the ETC cable connector block (this usually affects Mercedes and Volvo vehicles). If there is a single Yellow (B) plug already in the back of the tachograph leave it in place and leave the Yellow plug looped to itself. Find out more here - https://www.tachosys.com/digiDL-H For any questions please contact us at enquiry@prosysdev.com