How to Make a Moonshine Still - Part 4 - Building a Still Boiler скачать в хорошем качестве

How to Make a Moonshine Still - Part 4 - Building a Still Boiler

This is part 4 in our series on how to build a moonshine still. In this video will be shaping the boiler. We are going to start by bending the teeth up on the boiler. So we will bend the tabs up with the pliers by very meticulously grabbing each tab and just bending it upwards so it sits at a final resting place of about 90 degrees to the boiler. You want to grab the tab right where it meets the boiler and just bend it up. If you have a pair of sheet metal pliers it will make this job go a lot faster. I have some but I figure most folks won't so I just went ahead and did this with a regular pair of pliers. Like I said, it takes a bit longer but you get the job done just the same. Moonshine Still Kit: https://www.clawhammersupply.com/prod... How to Make a Moonshine Still: https://www.clawhammersupply.com/blog... Part 1 -    • How to Make a Moonshine Still - Part 1 - T...   Part 2 -    • How to Make a Moonshine Still - Part 2 - S...   Part 3 -    • How to Make a Moonshine Still - Part 3 - P...   Part 5 -    • How to Make a Moonshine Still - Part 5 - H...   Part 6 -    • How to Make a Moonshine Still - Part 6 - B...   Part 7 -    • How to Make a Moonshine Still - P7 - Build...   Homemade stills such as this one are often called "moonshine stills." However, this distiller is primarily designed to distill water and essential. With the proper permits and safety precautions, it is capable of distilling high proof fuel alcohol and spirits such as moonshine. However, doing so is illegal without a federal fuel alcohol or distilled spirit plant permit as well as relevant state and local permits. Our distillation equipment is designed for legal uses only and the information in this video is for educational purposes only.