Скачать с ютуб Flysky i6 RC Transmitter + i6A RX - Beginners Guide - I finally go 2.4 Ghz! в хорошем качестве

Flysky i6 RC Transmitter + i6A RX - Beginners Guide - I finally go 2.4 Ghz!

Buy here https://amzn.to/3v6kKfh Finally bit the bullet and went 2.4 ghz with this very cheap transmitter, FlySky i6 , which came with a with a FlySky FS iA6 receiver and was just £36. 6 channels and 20 model memory. More expensive now but still a good buy. This video is a quick look at the transmitter and for beginners, shows how you connect a receiver to a speed controller (ESC), brushless motor and servos. Warts and all video! I've been doing this stuff for some years but still made a couple of mistakes. Watch and learn! (Eachine i6 is the same I understand.) Transmitter https://amzn.to/3v6kKfh Flight test web site foam build models and plans https://www.flitetest.com/scratch-bui... Build instructions for the model with red stripes is here    • How To Make RC Model Airplane Fun-Fly...   Manuals and FW https://www.flysky-cn.com/fsi6 0:00 Introduction 1:20 default start up is plane/glider mode 1:29 idiot mistake one alarm is sounding because one switch was not up! 1:38 Mode 2 is left hand throttle 2:15 it's only the quick start guide 2:27 a link to the full manual is below 3:26 you will need to bind if you buy a new receiver 4:27 power from ESC goes into no 3 channel 4:31 black or brown is negative 4:34 don't do this with a propellor fitted! 4:37 and I've disconnected the motor 4:43 check switches up throttle closed 5:54 always turn on tx first and power model second 6:06 the 3 way switch was in the middle position! 6:32 alarm warning transmitter battery low voltage FS-16 6:41 idiot mistake two read manuals before doing stuff! 7:24 loads of free foam board plans on Flight Test web site linked below! 7:53 my modified FT Versa 8:02 FT Pun Jet