У нас вы можете посмотреть бесплатно BMW 316i F30 N13 coolant pump replacement или скачать в максимальном доступном качестве, видео которое было загружено на ютуб. Для загрузки выберите вариант из формы ниже:
Если кнопки скачивания не
загрузились
НАЖМИТЕ ЗДЕСЬ или обновите страницу
Если возникают проблемы со скачиванием видео, пожалуйста напишите в поддержку по адресу внизу
страницы.
Спасибо за использование сервиса ClipSaver.ru
Car: BMW 316i F30 /2012, N13 engine Water pump part number: 11517648827 Water Pump Pulley part number: 11517619020 Venting cooling system Filling without vacuum filling unit: cold engine. Open bleeder screw on coolant expansion tank. Top up the cooling system to the lower edge of the expansion tank until the coolant level in the expansion tank no longer drops. (I added over 4 liters of coolant to the MAX level) Connect battery charger. Switch on ignition and low-beam headlight. Switch off the air conditioning. Set heater to maximum temperature and turn blower down to lowest speed. Driving experience switch must not be set to ECO PRO! Wait for approx. 1 min. (I expected the auxiliary electrical pump to circulate the coolant but this didn't seem to happen) You may need to top up the coolant to the lower edge of the expansion tank. (coolant level did not drop) Tighten bleeder screw on coolant expansion tank. Close coolant expansion tank. Start engine. Draining procedure: Press accelerator pedal 10x up to approx. 3000 rpm 1 s increased idle to approximately 1200 rpm Press accelerator pedal 10x up to approx. 3000 rpm 1 s increased idle to approximately 1200 rpm Press accelerator pedal 10x up to approx. 3000 rpm Stop engine. Fill coolant expansion tank to 100 ml above maximum. (I filled it again to the MAX level) After this I took a drive to circulate and bleed the coolant with the heater set to maximum temperature) until I got the coolant temperature up to the normal operating temperature. I did not need to top up the coolant again after the ride.