Toyota Avensis, D4D, 2.0, T270, Front Right Control Arm Replacement 2008 to 2015. скачать в хорошем качестве

Toyota Avensis, D4D, 2.0, T270, Front Right Control Arm Replacement 2008 to 2015.

www.cardiyrepair.com Replacing the control arm on a Toyota Avensis 2.0 D4D T27 involves the following steps: 1. Park the car on a flat surface and engage the parking brake. 2. Loosen the lug nuts on the wheel where the control arm is being replaced. 3. Jack up the car using a floor jack and secure it with jack stands. 4. Remove the lug nuts and take off the wheel. 5. Locate the control arm and identify the mounting bolts that connect it to the suspension and the frame. 6. Use a socket wrench and an appropriate socket to remove the mounting bolts. It may be necessary to use a breaker bar or impact wrench to loosen rusted or stuck bolts. 7. Detach any other components that are connected to the control arm, such as the sway bar link or the tie rod end. 8. Remove the old control arm from the car. 9. Install the new control arm by reversing the steps above. 10. Tighten the mounting bolts to the manufacturer's recommended torque specifications. 11. Reconnect any other components that were detached during the removal process. 12. Install the wheel and tighten the lug nuts. 13. Lower the car to the ground and remove the jack stands. 14. Use a torque wrench to tighten the lug nuts to the recommended torque specification. The torque specifications for the bolts on the wishbone of a Toyota Avensis T27 can vary depending on the specific year, make, and model of the car, as well as the size and type of the bolts. However, in general, the torque specifications for the bolts on the wishbone of a Toyota Avensis T27 are as follows: Lower wishbone front bolt: 123 Nm (91 lb-ft) Lower wishbone rear bolt: 123 Nm (91 lb-ft) Upper wishbone front bolt: 83 Nm (61 lb-ft) Upper wishbone rear bolt: 83 Nm (61 lb-ft) It is important to note that these torque specifications are only a general guideline, and you should always refer to the specific service manual or technical data for your vehicle to ensure that you are using the correct torque specifications for your particular application. It is important to note that the above steps are general guidelines and the exact procedure may vary depending on the year and model of your Toyota Avensis. Therefore, it is recommended to consult the vehicle owner's manual or a qualified mechanic for specific instructions.