I Fried My Friend’s 3D Printer... and Had to Fix it. скачать в хорошем качестве

I Fried My Friend’s 3D Printer... and Had to Fix it.

This was supposed to be a quick tune. About a week ago, my friend John dropped off his 2018 Creality CR-10 so I could help dial it in. During what should have been a routine tuning session, I made one mistake — shorted a heater wire — and instantly fried the control board. What followed wasn’t a simple repair. Over the next week, that “quick tune” turned into a full teardown, rebuild, and accidental custom machine. New electronics, new configuration, and a lot of problem-solving, the CR-10 ended up performing better than either of us expected. This video documents the entire process as it happened — from the initial failure, through the rebuild, to the final result. If you’ve ever thought “this will only take a few minutes,” this one’s for you. Chapters / timeline: Day 1 – A quick tune goes wrong Day 2 – Diagnosing a dead board Day 3–6 – Rebuild and configuration Day 7 – Final results If you enjoy real-world 3D printer troubleshooting, tuning, and honest rebuilds, consider subscribing. StealthySwiss Link: https://www.thingiverse.com/thing:517...