LD Systems MEI 100 problem with multiple in ear systems скачать в хорошем качестве

LD Systems MEI 100 problem with multiple in ear systems

In this video I will show you a solution that I found out when I was putting together my closed wireless in ear system for my band. I was using the LD Systems MEI 100 and when I was using multiple units I ran into problems. So if you are having problems with you in ear system then this video might help you. do you have a problem with your in ear system does it sound like an old radio well stick around I might have a nursery hi I'm max a from the band psyckadeli and today I am going to show you my new in ear system and I also would like to address a problem that I had would assist them when connecting it all together so what was the problem well when I connected all these together and put them on when I was using one of these receivers it made pretty much a noise of an old radio when I was walking around it was making all crazy funny noises and it wasn't actually very pleasant to listen to at all when I built this system I went for this LD model that wasn't the most expensive one and it wasn't the cheapest one either I thought that you had a lot of opportunities here because you could set this frequencies and a system was licensed free which was actually very very good so I read up in the manual how you were supposed to hook it up and also set the channels and groups to be able to use multiple system using this technique I could see in the manual that there was basically two options to vary the frequencies coming from the transmitter to the receiver we had groups and they had channels so I thought well we're a group right so what I did was I set Group one on all transmitters and and then I just basically changed the channels to 1 2 3 & 4 but unfortunately that wasn't enough apparently because when I started it up it was making a lot of noise it was basically like an O radio being turned to the next station and it was terrible I thought it was something wrong with the system so my first setup was as I said that group one on all of the components and then I would just change the channels on the transmitter to go to the receivers so a second setup was to use different grooves and then have the same shells so I set it to Group 1 group 2 group 3 and group or but then I would just use 1 2 3 4 or just 1 1 1 1 on the channels for the transmitters but unfortunately he still had the same problem and I was really getting frustrated and I thought that this was probably something wrong with equipment or I was standing too close to the transmitters I was walking around in my house and I pretty much had the same problem all the time and the problem was that when I was turning on all the transmitters that's when I had a problem but because being old and stubborn at this age I decided to try something completely different I decided to make a settings with the group 2 channel 2 on the first one then group 4a channel 4 on the second one group 6 and channel 6 on the third one and then group 8 and channel 8 on the fourth one and it was magic that actually solved the problem and then I realized that hey wait a minute the frequencies must have been too close together because as you can see here the frequency now are more far apart and that actually helped it a lot so it seems that you have to have values that separate each other is quite a far away because otherwise it will interfere when you're having multiple setup like this I hope this video has helped you and if you like to see more of these videos please subscribe to the channel and keep your eyes out for more cool stuff on being in a band