Install: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector on a 2003 Dodge Durango скачать в хорошем качестве

Install: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector on a 2003 Dodge Durango

Click for more info and reviews of this Tekonsha Custom Fit Vehicle Wiring: https://www.etrailer.com/Custom-Fit-V... Check out some similar Custom Fit Vehicle Wiring options: https://www.etrailer.com/fitguidet1.htm Search for other popular Dodge Durango parts and accessories: https://www.etrailer.com/vehicle/2003... https://www.etrailer.com Don’t forget to subscribe!    / etrailertv   Full transcript: https://www.etrailer.com/tv-install-t... Today on this 2003 Dodge Durango we're going to be installing wiring harness part number 118334. In the location of the ports we are going to be plugging our wiring harness into are located directly behind the tail lights of both the drivers and passengers side of the vehicle. In order to gain access to those these are two Phillips head screws per side, you just want to go ahead and remove those and allow the tail light to pop off. With the tail light pulled back you can see on the back side of the tail light is the connector we are going to be using. We will next need to go ahead and separate the connector from the tail light, and to do that if you look on the top side of the connector there is a red tab here, you want to go ahead and press it over, and that releases the safety clip, and then there is a push button release right here on the top as well, press that in, and pull the two pieces apart. We will go ahead and do that for the passengers side tail light as well and then we will go ahead and start plugging our harness in line. So starting over here on the drivers side we are going to go ahead and start plugging our harness in line. There are two sets of connectors obviously one for the drivers and one for the passengers sides, and ones for the drivers side has the red, yellow and brown wires integrated into them. There's the one end of our connector into the vehicle side connector, and again we want to make sure we push our red tab over to lock it in. I'm going to hold off plugging the tail light back in to the other end just yet, because what we are going to need to do is take not only the passengers side connector, but the 4 pole end as well, and we need to get them underneath the vehicle and to do so we are going to feed them through the opening in the body and in the bumper here. Okay the next piece that we come to in our harness is the converter box here, and if you rotate it over you will see we've got double sided tape on it. You want to go ahead and adhere to a part of the body structure here to keep from it jiggling around loosely as we drive along. What I am going to go ahead and do is clean out the underside of the bumper, and actually take and adhere it up underneath there like so. Okay with all that accomplished we could go ahead now and plug the other end into the back side of the tail light, and you could go ahead and put it back into place. Okay with the drivers side tail light on, we can continue underneath the vehicle now where were going to go ahead and route our remaining wires in place. The 4 pole I am going to go ahead and route to the center of the vehicle where you can either tie it off at your trailer hitch or use your mounting bracket to hold it in place. And then we are going to go ahead and do the same thing with the passenger side connectors, however these obviously we will take all the way across and up through the opening between the body and the bumper on the passengers side. And then go ahead and repeat the same process over here on the passengers side. And with that, that will conclude the installation of wiring harness part number 118334 on a 2003 Dodge Durango.