Rainin BenchSmart 96 | Install/Switch Pipetting Heads | Semi-Automated Pipetting Workstation скачать в хорошем качестве

Rainin BenchSmart 96 | Install/Switch Pipetting Heads | Semi-Automated Pipetting Workstation

Installing & Removing Pipette Heads Start BenchSmart, choose a user, and tap Continue to initialize. Next, if no pipetting head is present, you are prompted to load one. To change heads when BenchSmart is already on, tap the Head Change icon on the left of the touchscreen. You’ll see a reminder to eject tips, then Continue. The zero-point-five to twenty microliter head has small red pull handles on the front. It’s packed on a tip box with a red lid. The five to two hundred microliter head has green pulls – and a box with a green lid. …And the one hundred to one thousand microliter head has blue pulls and a blue-lidded box. Heads weigh 5.2 pounds each. Raise the front console to its maximum height. On the front, take off the transparent plastic cover plate – which is lightly affixed with magnets. Make sure the small metal tabs to the left and right of the head carriage are flipped up vertically. The head will slide into the lower and upper slots. Using the plastic tip box as support under the head, slide the head all the way into the top and bottom slots until it’s fully in place. Close the two tabs to a horizontal position, snap the cover back in place and on the touchscreen, press Done to initialize the head. To remove a head, tap the Head Change icon on the left of the touchscreen. Take off the transparent plastic cover on the front console. Then flip the small metal tabs on the left and right of the head carriage up vertically. Before you slide the head out, support it underneath with a matching-sized plastic tip box. https://www.mt.com/global/en/home/pro...