TRANSFER Case Oil Change | Toyota Tacoma 4Runner T100 Tundra скачать в хорошем качестве

TRANSFER Case Oil Change | Toyota Tacoma 4Runner T100 Tundra

How to change you 1st generation Toyota Tacoma transfer case gear oil. This general process applies to 4Runner, T100, and Tundras with slight variations in steps! Tool List: socket wrench and/or breaker bar (liquid wrench or PB blaster may be needed) 24mm socket SAE 75W-90 gear oil GL4 or GL5 transfer case has 1.1 quart capacity, advise buying at least 2 quarts. Fill transfer case until oil begins to dribble out of FILL hole small wire brush oil catch pan torque wrench (optional in my opinion, decide at your own risk) fill and drain plugs both 27 ft-lbs torque specification (2) washers, Toyota part #90430-18008 *If the video was helpful, remember to give it a "thumbs up" and consider subscribing.* Disclaimer: Due to factors beyond the control of Engineered Mojo, I cannot guarantee against improper use or unauthorized modifications of this information. Engineered Mojo assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Engineered Mojo recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Engineered Mojo, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Engineered Mojo.