How to Replace the Impeller on Flygt M 3068 Grinder Pumps скачать в хорошем качестве

How to Replace the Impeller on Flygt M 3068 Grinder Pumps

This is an informational video on how to replace the impeller on Flygt M 3068 grinder pumps. This video is intended as a general reference for technical personnel tasked with maintaining pump performance and ensuring the replacement process is done safely and effectively. This video is NOT intended to serve as a step-by-step, fail-safe checklist. Projects vary and may require additional steps provided for in the Manual not included in this video. The video demonstrates how to dismantle and remove the impeller, and then how to install the new impeller. The Flygt M 3068 grinder pump is a high-performing submersible, centrifugal pump for pumping wastewater in residential, commercial and agricultural applications. The grinder pump reduces waste content to fine slurry, pumped through small-diameter pipes. For more information about the pump: https://www.xylem.com/en-nz/products-... Contact us here: https://www.xylem.com/en-nz/brands/fl... Subscribe to our channel for more insights on how our innovative solutions are transforming water & wastewater management. Disclaimer Warning: Carefully review the product specific Installation, Operation and Maintenance manual (“Manual”) before tampering with the product in any way. All user safety rules and instructions contained in the Manual, as well as any other applicable safety rules, must be observed. This video is provided as general reference only, as a complement to the Manual, and cannot be relied upon as a substitute for professional advice. Failure to follow all instructions in the Manual may void the manufacturer's warranty. If there is a question or any uncertainty regarding the intended use or maintenance of the equipment, contact a Xylem representative before proceeding. Xylem cannot be held responsible for any actions or inactions undertaken as a result hereof. 00:00-00:14 Introduction 00:14-00:35 Remove impeller screw and cutter wheel 00:35-00:53 Remove cutter ring 00:53-01:24 Remove the suction cover 01:24-01:44 Remove the impeller 01:44-02:06 Mount the new impeller 02:06-02:38 Mount suction cover, cutter ring and cutter wheel 02:38-04:02 Check measurements 04:02-04:44 Re-fit impeller and suction cover 04:44-05:12 Re-fit cutter wheel and impeller screw 05:12-05:47 Check clearance 05:47-06:07 Finishing steps #Flygt #ServiceVideos