TURBO ROTARY! Flooded 1987 Mazda Rx-7 Turbo II Engine Teardown. A Big Unknown Lump скачать в хорошем качестве

TURBO ROTARY! Flooded 1987 Mazda Rx-7 Turbo II Engine Teardown. A Big Unknown Lump

For Parts go to www.Importapart.com or email us at [email protected] Today we are tearing down something special, the Turbocharged 13B Rotary engine out of a 1987 Mazda Rx7 Turbo II. Every week I make a new teardown video on a blown up, core, or suspected bad engine. These get torn all the way down to figure out what happened, why it happened and perhaps what parts I can recover to resell. Here are a few favorites: GM 3800 Series III Teardown    • 'BAD' GM 3800 L26 V6 Engine Teardown. Why ...   Bentley/Rolls Royce 6.75Litre Teardown    • BROKEN BENTLEY / ROLLS ROYCE 6 ¾ L-Series ...   Northstar V8 Teardown    • Customer Returned This Cadillac Northstar ...   Ford 300 4.9L Teardown    • FINALLY! A "Bad" Ford 4.9L 300 Straight 6 ...   My name is Eric and I own and run a full service auto dismantling business and part of our model includes dismantling bad engines to salvage the good parts from and recycle the rest. This particular engine was a giant unknown. All I knew is that its from an 87 Turbo II and the car was not nice/had been flooded. Regardless of whatever that situation was, the parts alone are hard enough to find that I was able to get the engine, transmission and rear end from the car before it was crushed and shredded. This is the teardown of the engine to see just how bad it was. As always I hope you enjoyed this video. I love all of the comments, feedback and even the criticism. Catch you on the next one! -Eric 00:00 Intro 03:55 Pulling the spark plugs and inspecting them. Oh, that's new. 04:51 Removing the AC Compressor and power steering pump 06:03 Unbolting and removing the smug pump 07:36 inspecting the turbo 09:56 I can't believe I got these nuts off, the turbo I mean 12:58 Pulling the turbo off of the exhaust manifold 14:35 Unbolting the exhaust manifold 16:20 Staring to remove the upper plenum and throttle body 18:53 The final steps in removing the upper plenum 20:13 Starting to remove the lower plenum 21:11 THE ICK 22:29 removing the rats nest 24:09 unbolting the rest of the belt drive 24:50 Pulling the water pump and OH MY GOD, what is that? 25:52 Unbolting the front E-shaft pulley 27:26 Rust coming in clutch 28:32 unbolting the oil pan 30:08 zipping out the front cover bolts and removing the cover, oil pump drive and counter weight 31:37 Flywheel removal 32:24 Unbolting the tension bolts, wowza were these tight! 35:00 Pulling the front iron, front housing and front rotor. WOW 38:13 Splitting the rear iron, rotor and rotor housing removal 39:16 Full inspection or eccentric shaft, irons, rotors, rotor housings, apex seals, side seals and corner seals. Really Impressed!! 44:02 Summary